F A Q (Frequently Asked Questions)
Please click on the question that you would like to view.
How easy are they to install?
The Landing Lights have been cleverly designed to allow installation without the use for any tools. However, careful planning is recommended. Always layout the lights and test their operation so that you can be sure that you are achieving their optimum.
For further installation instructions, read the Installation Guide.
How many lights can be connected to one controller?
A maximum of 20 lights can be fitted with the standard PSU and a maximum of 60 with the high power version.
Where can I fit the lights?
They can be installed almost anywhere with a flat surface of at least 50mm x 50mm!
The lights are IP68 rated and are powered by only 10 volts which means that they are safe to use in up to a meter of water!
Why do the lights 'go off' when turning the brightness up?
This is the overload protection feature. If there is a short circuit or other fault the RX1 will sense this and turn the lights off. Try unplugging the lights one at a time to detect a faulty unit. If fault persists, contact us.
How does the remote control work?
Simply push the button on the remote or the power button on the RX1 briefly to turn the lights on and off or keep the button depressed to gradually increase/decrease the brightness.
How do I plug the lights in to the controller?
The BLUE tab must face DOWN when the cable is pushed in to the connector.
What is the smoke alarm activation feature?
This feature is in no way intended to be a failsafe device. Do not rely on this function alone. The RX1 has the ability to 'listen' for most common smoke alarms. To activate the function, push a small pen in to the slot and rotate the control 'Click'. The sensitivity is adjusted by trial and error. Maximum range is determined by the sensitivity and location of the RX1. For best performance locate the RX1 directly below the alarm.When activated the lights will automatically come on. Use the button to turn them off again.