Fitting Guide

Illumination without Installation™

Landing lights have been designed with ease of fitting firmly in mind, removing the need for complex and expensive fitting by professionals.

Before making any permanent installation, lay out all the lights in their appropriate locations in order that you can test the light output and re-arrange as necessary.

Bare in mind the following:

  • The controller and power supply MUST be indoors.
  • The controller needs to be within reach of a power outlet.
  • If you wish to use the smoke alarm activation, the controller needs to be as close as possible to the smoke alarm.
  • Each light has a 6m long, flat (0.1mm) cable that can be slipped into thin gaps.

1
1
1
1


Simply place the light module in an appropriate location, apply the sticky back to the module and affix it to the surface. Next, cut a strip of double sided tape to the right length, apply to the back of the flat cable and affix onto the surface running the cable discretely to the controller. The cable is virtually invisible and can be painted too.